有下列情形之一的，存款人应向开户银行提出撤销银行结算账户的申请()。

te command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0".Whic h of the following is most likely to have caused this output to occur on R1？（）

A. R1 has been configured with an ip default- network 2.0.0.0 command.

B. R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.

C. R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.

D. Another router has been configured with an ip default - network 2.0.0.0 command.

E. Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.

A. A configured router prompts for a password

B. A configured router goes to the privileged mode prompt

C. An un configured router goes into the setup dialog

D. An un configured router goes to the enable mode prompt

t powered up？

A．A configured router prompts for a password

B．A configured router goes to the privileged mode prompt

C．An un configured router goes into the setup dialog

D．An un configured router goes to the enable mode prompt

A. Static NAT

B. Dynamic NAT

C. Dynamic NAT with overload

D. Port Address Translation

E. None of the above

h has been configured with two vlans，and route-on-a-stick is being configured on the router for inter-vlan routing. A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate？（）

A.one

B.three

C.two

D.zero

A.The Gallant router has the wrong LMI type configured

B.Inverse ARP is providing the wrong PVC information to the Gallant router

C.The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command

D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct

E.The IP address on the serial interface of the Attalla router is configured incorrectly

A.The Gallant router has the wrong LMI type configured

B.Inverse ARP is providing the wrong PVC information to the Gallant router

C.The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command

D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct

E.The IP address on the serial interface of the Attalla router is configured incorrectly

has been configured with two vlans,androute-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate？（）

A.one

B.three

C.two

D.zero

A. The Gallant router has the wrong LMI type configured

B. Inverse ARP is providing the wrong PVC information to the Gallant router

C. The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command

D. The frame-relay map statement in the Attalla router for the PVC to Steele is not correct

E. The IP address on the serial interface of the Attalla router is configured incorrectly

A.The Gallant router has the wrong LM Itype configured

B.Inverse ARP is providing the wrong PVC information to the Gallant router

C.The S3 interface ofthe Steele router has been configured with the frame-relay encapsulation ietf command

D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct

E.The IP address on the serial interface of the Attalla router is configured incorrectly