On ZXCTN6100, which of the following interfaces is used for system debugging? ()
A.QX interface
B.LCT interface
C.OUT interface
D.GPS IN interface
A.QX interface
B.LCT interface
C.OUT interface
D.GPS IN interface
第1题
A.ZXCTN6100 (except for the V1.0 that does not support OSPF)
B.ZXCTN6200
C.ZXCTN6220
D.ZXCTN6320
第2题
A.UNI interface configuratio
B.Static MAC configuratio
C.configuratio
D.VLAN interface configuratio
第3题
A.STM-1 signal of 155M
B.GE9, GE10 Ethernet ports
C.GPS port
D.BIT/S external clock of 2M
第4题
A.For ZXCTN6100 equipment of Version 1.0, monitoring IP of EMS is LOOPBACK1 of the equipment
B.For ZXCTN6100 equipment of Version 1.1, monitoring IP of EMS is LOOPBACK1 of the equipment
C.For ZXCTN6200/6300 equipment, monitoring IP of EMS is interface IP of the equipment
D.For ZXCTN6200/6300 equipment, monitoring IP of EMS is LOOPBACK IP of the equipment
第5题
A.Each line side interface (NNI) of ZXCTN equipment should be configured with EMS VLAN, and each VLAN should be configured with proper EMS IP;
B.ZXCTN6300/6200 support L3 routing protocol (e.g. OSPF). In 10GE ring, EMS info is forwarded through L3, and two adjacent ports on one link belong to one VLAN domain and one IP network segment;
C.After ZXCTN6100 device is upgraded into agent version, it is recommended to use L3 monitoring mode.
D.EMS VLAN ID range is in 3001~4093, and these VLAN values are automatically shielded on T31 to prevent collision between EMS VLAN and encapsulation VLAN;
为了保护您的账号安全,请在“上学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!